Load shifting changes when energy is taken from the grid. Peak shaving reduces the highest grid demand during a defined measurement interval. A battery may support both, but each objective needs its own control rule, power requirement and available energy.

For an industrial buyer, the starting document is the site’s interval load record and tariff structure. A monthly energy total cannot show whether the main opportunity is a brief demand peak, a long expensive period or a combination.

Compare the operating objectives

Question Load shifting Peak shaving
Main objective Move grid energy consumption between periods Limit grid demand during relevant intervals
Important input Energy prices and available charging periods Demand measurement rules and load peaks
Battery requirement Enough energy for the target window Enough power and energy for the peak event
Control trigger Schedule, price or forecast Measured or predicted demand relative to a limit
Common planning error Ignoring losses and the next recharge Sizing from average load instead of peak shape

NREL’s System Advisor Model battery documentation describes dispatch options for peak shaving and time-varying electricity prices. A site assessment should likewise evaluate the two objectives separately before combining them.

Commercial storage cabinet beside an industrial building

A short peak can need high power but modest energy

Imagine a factory normally importing 200 kW. A process raises demand to 300 kW for 15 minutes. Holding import to 240 kW during that simplified event requires 60 kW of battery output and 15 kWh delivered.

If the same 60 kW reduction is needed for three hours, the energy requirement becomes 180 kWh. The power is unchanged; the required energy is twelve times larger. These examples assume rectangular load events and ignore losses, so they illustrate sizing logic rather than a completed design.

Demand charges can depend on interval averaging and other tariff provisions. Obtain the actual rules before estimating savings. A momentary spike in a monitoring graph may not equal the billed peak.

Energy shifting needs a complete daily balance

For a hypothetical 100 kWh AC delivery target and an assumed 90% AC-to-AC round-trip efficiency, approximately 111.1 kWh must be charged at the same measurement boundary. This is an illustrative energy balance, not a product efficiency claim.

The commercial calculation also needs charging cost, discharge value, auxiliary consumption, battery degradation and any demand impact caused by charging. A low-price charging period is not useful if charging creates a new billed demand peak.

When solar is involved, record the energy that would otherwise be exported or curtailed. Do not count the same solar energy as both export revenue and battery charging benefit.

Combining the two functions requires priorities

A battery scheduled to discharge early in an expensive period may lack the reserve needed for a later factory peak. The control plan should state whether peak limitation, energy shifting or backup reserve takes priority.

Ask for an operating simulation using interval data. Review days with long peaks, low solar production and limited recharge opportunities, not only an average day. Include the response when the battery reaches a limit or the meter signal is lost.

Choose a cabinet after defining the duty

The SU261C131LM lists 131 kW and 261 kWh, while the SU522C131LM lists the same rated power with 522 kWh nominal energy. Those different ratios can be assessed against different discharge windows; neither is a universal recommendation for peak shaving or shifting.

For a useful commercial storage inquiry, provide interval consumption data, the tariff document, existing solar generation, import/export constraints and required backup reserve. Send these through LAINERGY’s contact page and request a duty-based comparison with its assumptions shown. Keep projected savings separate from measured results.